Publicidad
Hardware Usage Guide
HOW TO USE A TWIST-LOCK
1.
Push a TWIST-LOCK® FASTENER
into the large hole in the part.
Step 5
å
To begin assembly, push four SAUDER TWIST-LOCK® FASTENERS (10F)
into the large holes in the MODESTY PANEL (D).
10F
www.sauder.com/service
FASTENER
®
Do not tighten the TWIST-LOCK® FASTENERS in this step.
10F
2.
1. Insert the dowel end of the FASTENER into the
hole of the adjoining part.
NOTE: The dowel end of the FASTENER must
remain fully inserted in the hole of the adjoining
part while locking the FASTENER.
2. Tighten the FASTENER with a Phillips
screwdriver as tight as possible.
D
426140
Dowel end
2
Page 11
Publicidad
