Publicidad
Step
Step 11
å
Separate the EXTENSION SLIDES (40MC) from the EXTENSION RAILS (40MA) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten a EXTENSION RAIL (40MA) to the UPRIGHT (C). Use two GOLD 5/16" FLAT HEAD SCREWS (3S) through
holes #1 and #4.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the UPRIGHT. Turn a SCREW into
this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
40MC
Push the black lever in and pull the SLIDE from the RAIL.
GOLD 5/16" FLAT HEAD SCREW
(4 used for the RAILS)
www.sauder.com/service
3S
Open end
40MA
C
2
1
426140
7
4
3
Page 17
Publicidad
