Publicidad
Step 1
å
Assemble your unit on a carpeted floor or on the empty
carton to avoid scratching your unit or the floor.
å
Turn two BLACK 9/16" FLAT HEAD SCREWS (32S) into
the LEFT END (B) until the shoulders of the SCREWS rest
on the surface of the LEFT END.
å
NOTE: Do not overtighten the SCREWS.
å
Slide a END MOLDING (F) onto the LEFT END (B). Line
up the grooves in the MOLDINGS over the heads of the
SCREWS in the LEFT END.
å
NOTE: The MOLDING should be even on both edges of
the ENDS.
å
NOTE: If the MOLDING comes up off of the SCREWS,
remove it and slide it on again.
Page 6
Look for this icon. It means a video assembly tip is
available at www.sauder.com/service/tips
Find the numbered video or scan the QR code.
B
BLACK 9/16" FLAT HEAD SCREW
(2 used in this step)
426140
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
Shoulder
32S
www.sauder.com/service
0
F
Publicidad
