Publicidad
Step 27
Step
1
D12
N
Groove
å
Insert the DRAWER SIDES (D12 and D13) at an angle
into the slot at each end of the DRAWER FRONT (N).
3
Be sure the
DRAWER
BOTTOM
inserts into the
DRAWER BACK
groove.
å
Fasten the DRAWER BACK (D150) to the DRAWER SIDES (D12 and D13). Use four BLACK 1-9/16" FLAT HEAD
SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (D953) inserts into the groove of the DRAWER BACK (D150).
www.sauder.com/service
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D13
D150
D953
D12
2
D12
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D953) into the grooves in the
DRAWER SIDES (D12 and D13) and DRAWER FRONT (N).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D13
426140
9
With the palm of
your hand, tap
the DRAWER
U n
fi n
BOTTOM down
s u
i s h
r f a
into the groove.
e d
c e
D953
D13
N
30S
(4 used in this step)
Page 33
Publicidad
