Publicidad
T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Locate the vehicles tail light
wiring harness under the rear of
the truck along the inside of the
left (drivers) side frame rail (Fig.
1 & 2).
The harness will contain
connectors similar to those on
the T-Connector harness.
3. Carefully separate the vehicle
connectors by pressing down on
the secondary locking tab. Take
care not to damage the locking
tabs.
4. Position the T-Connector
between the vehicle connectors and firmly press the
harness ends of the
T-Connector into the vehicle connectors separated in
step 3. Ensure the locking tabs are engaged.
5. Find a clean area ear the wiring harness to attach the
ground screw. Clear away any dust or debris and drill a
7/64" hole.
Caution: Do not drill into any exposed surfaces or
Fig. 1
Fig. 2
Publicidad
