Electrical Safety - Jacuzzi SKYLINE 190 Manual De Preinstalación

Ocultar thumbs Ver también para SKYLINE 190:
Tabla de contenido

Publicidad

Le parti contenenti dei componenti elettrici, ad ecce-
zione dei dispositivi di comando remoto, devono esse-
re posizionati o fissati in modo che non possano cadere
dentro la vasca. Componenti e apparecchiature sotto
tensione non devono essere accessibili a chi è immerso
nella vasca.
Nel caso l'impianto elettrico dell'immobile non sia in
grado di assicurare un'alimentazione costante, si con-
siglia d'installare uno stabilizzatore di tensione prima
dell'apparecchiatura, opportunamente dimensionato
per la potenza della stessa.
Le vasche idromassaggio Jacuzzi® sono provviste di
morsetto, posto nelle vicinanze della pompa e contrad-
distinto dal simbolo , per il collegamento equipoten-
ziale delle masse metalliche circostanti, come previsto
dalle norme EN 60335.2.60.
ATTENZIONE! Scollegare l'apparecchiatura dalla linea
di alimentazione elettrica prima di effettuare qualsiasi
intervento di manutenzione.
Info
We recommend installing the bathtubs to already finished
walls and flooring (already tiled or laid).
In the instance of built-in tubs, access to the motor pump and
electrical box must be permitted to carry out any maintenance
operations (see technical specifications, ref. 6a, 6b). Access can
be closed off using removable panels. The system must also be
equipped with adequate ventilation, with holes between the
tub coating and the removable panels, or there should be evenly
spaced and fully unobstructed openings.
The panels must be securely attached and a suitable tool
must be used for their relative removal.
Openings, holes and grilles used for ventilation purposes must
not permit the infiltration of objects with diameter of Ø 12 mm.
The flooring must be excavated to position the siphon
(see the relevant instructions).
ATTENTION: (IEC 60335-1/A2) The pressure of the wa-
ter system supplying water to the appliance must not
exceed 600 k Pa (6 bar).
Electrical wiring setup
The power supply cable must be installed near the indicated po-
sition
(see technical specifications,
so it can be connected to the box (fastened to the frame). The
cable can follow various paths provided that there are no loose
connections; refer to the chapter on "Electrical safety".
It is recommended to prepare the electrical power supply with
one single-phase line (voltage between phase and neutral:
220-240V).
The device can be powered with a double phase line, providing
that the voltage between phases is 220-240V.
ATTENTION: With the models equipped with heater,
ensure that the building's electrical supply is able to
provide the power required (see relevant instructions)
and that it is specifically dimensioned.

Electrical safety

Jacuzzi®" hydromassage products are safe appliances, manu-
factured according to EN 60335.2.60, EN 55014, EN 55014-2.
They are tested during manufacturing in order to guarantee
user safety.
Installation must be carried out by qualified and authorized
personnel, in compliance with the national provisions in force.
7
ref. 2), leaving it long enough

Publicidad

Tabla de contenido
loading

Tabla de contenido