Important - RIB K500 Manual Del Usuario

SIMPLIFIED INSTRUCTIONS FOR K500 WITH K2007 Wi-Fi
1 Connection of the motor, limit switch and receiver (done at the factory)
st
NO
NC
C
GREEN => PED
GREY => COM
YELLOW => EDGE
BLACK => PHOT
WHITE => CONTROL BUTTON
BROWN => A+ TEST
2nd Installing and adjusting the limit plate cams
Place the cams on the rack.
Tighten the two screws to lock them. How to
finely adjust cam intervention is explained below.
Release the motor (turn the key counter clockwise until
the limit is reached without forcing) and move the gate
by hand
Check when the cams are activated.
Note: The cams must press the electric microswitches
before the mobile part touches the mechanical
stops.
3rd Mounting, power supply, alignment and memorization of the NOVA Wi-Fi photocells
Attach the photocells to the poles or to posts.
Place micro-switch 1 set to ON (the other micro-switches must be set to OFF) on both the receiver and the transmitter.
Insert the AA batteries (cod. ACG9519) in the chamber checking their polarity.
Transmitter TX => The green LED of the transmitter comes on for 10 seconds indicating that it is working correctly, it then turns o
Receiver RX => The red LED comes on for 3 seconds, if it turns o after 3 seconds, position the optical groups until the red LED emits a constant light. Three minutes after inserting the batteries
the red LED turns o , for another 3 minutes push S3 PROG TX
Use the following procedure for memorization:
1. Set DIP 1 of the SW1 on the MASTER Wi-Fi to ON
2. Push the PROG RX button on the MASTER Wi-Fi => dual-colored EDGE PHOT 1 LED flashes red for 1 minute (the time necessary for memorization).
3. Push the S3 PROG TX button on the photocell receiver => on the MASTER Wi-Fi the dual-colored EDGE PHOT 1 LED changes from flashing red to green and a sound from the buzzer indicates
that the photocell has been memorized correctly, immediately the dual-colored EDGE PHOT 2 LED begins flashing red.
4. After one minute the dual-colored EDGE PHOT 2 LED turns o or, push the PROG. RX button 4 times to exit the memorization procedure => all dual-colored EDGE PHOT LEDs should be o .
4th Supplying power to the SPARK Wi-Fi blinker
Insert the three C batteries (cod.ACG9518) provided into the chamber checking their polarity
Do not mount the orange di user so as to be able to perform the memorization of the MASTER Wi-Fi card (point 7)
BLUE
NO
NC
C
BROWN
BLUE
M
BLACK
MOTOR
A
A
A

IMPORTANT

The motor is set to open towards the right.
If opening is to the left, the LSO and LSC wires on terminal block J2 and the V
and W wires on terminal block J7 must be reversed.
CAPACITOR
CONTROL BUTTON
but the transmitter remains active.