Sauder Summit Station 425015 Folleto De Instrucciones página 12

Step 7
Separate the EXTENSION SLIDES (35MC) from the EXTENSION RAILS (35MA) as
å
shown in the upper diagram below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (35MA) to the RIGHT END (A) and UPRIGHT (D). Use
å
four GOLD 5/16" FLAT HEAD SCREWS (3S) through holes #1 and #3..
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged
å
diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to fi nd the other hole
that lines up with the hole in the END/UPRIGHT. Turn a SCREW into this hole.
NOTE: The EXTENSION SLIDES (35MC) will be used later for the FILE DRAWER.
å
35MC
Push the black lever in and pull the SLIDE from the RAIL.
Open end
These holes
must be here.
Page 12
GOLD 5/16" FLAT HEAD SCREW
(4 used for the RAILS)
3
D
2
1
35MA
3S
2
A
3
425015
Open end
1
These holes
must be here.
www.sauder.com/service