Kärcher D 55 Manual De Instrucciones página 6

6 Move the side drawbars toward the top.
7 Install the connector tightly.
8 Insert the cable into the grommet.
9 Close and lock the machine cover.
10 Press the side push bars toward the
top.
6
11 Press down the rear surface of the ped-
al to raise/lower the cleaning head, re-
lease and let the pedal move upwards.
12 Position the centre holding bar in the
bottom position and insert the holding
pin.
13 Rotate the holding pin to the left by 90°
until it locks.
14 Create a water connection.
15 Insert the front drawbars into the guide
slots.
2
-
EN
16 Reinsert the locking tabs and press
them down until they lock.
17 Align the brush head - exterior edge of
the brush head must be parallel to the
appliance frame.
18 Slightly tighten the front push bars, do
not tighten.
19 Check whether the brush head has
been hooked in correctly. When you
use the pedal to raise/lower the brush
head, it must move freely.
Adjust the brush head after the installa-
tion.