Steelcase Answer Boundary Screens Manual De Instrucciones página 12

®
15a
BOUNDARY
SCREEN
Dual-Connect Split Installation
(continued)
15.
Attach to storage or worksurface.
(All Dual-Connect Boundary Screens must be
secured to storage or a worksurface. To qualify, the
worksurface or storage must be attached to the
Answer spine in two (2) places, with the exception
of storage-to-panel connector brackets. Storage
qualifies with only one (1) storage-to-panel
connector bracket attaching it to the Answer spine)
5"
a) If worksurface is included, use 'L' bracket.
'L' BRACKET
'L' bracket should be 5" from front of worksurface or
1" from front of Boundary Screen, whichever is
further back.
BOUNDARY
Install two (2) button head wood screws through
SCREEN
short side of bracket into Boundary Screen. Install
two (2) button head wood screws through long side
into the underside of the worksurface.
15b
If using a Boundary Screen with a return to replace
two (2) legs, use two (2) 'L' brackets. One in the
MINIMUM 8"
location described above, the other in the corner
where the Boundary Screens meet.
b) If attaching to storage, drill two (2) through holes
in storage end panel against Boundary Screen.
Holes should be at least 8" apart near the top of the
end panel. If steel storage, drill one hole through
the lock channel for strength.
Page 12 of 39
73085 Rev E