Dual-Connect Single-Sided - Steelcase Answer Boundary Screens Manual De Instrucciones

®
Dual-Connect Single-Sided Installation
1.
Place boundary screen on a clean, scratch resistant surface.
2.
Place Answer End-Of-Run (EOR) vertical
junction into pocket on boundary screen.
3.
Insert toe of lower hook bracket into the
appropriate slot (a) and swing into position (b),
lift lower hook bracket (c) and swing down into
pocket on boundary screen (d).
4.
Install five (5) flat head wood screws (provided).
5.
Insert upper hook bracket into the appropriate
slots (a), push upper hook bracket (b) and swing
down into pocket on boundary screen (c).
6.
Install five (5) flat head wood screws (provided).
7.
Place rectangular bracket inside pocket of
Answer EOR vertical junction. If four (4) holes are
visible, only install four (4) screws. If all six (6) holes
are visible, install all six (6) flat head wood screws.
8.
Install decorative cover as shown.
9.
Install glide as shown.
10.
Lift single-sided boundary screen assembly up
and assemble rest of Answer panel per assembly
direction # 939504607.
NOTE: If this single-sided boundary screen has a
return, go to page 6 for that installation process.
11.
See page 12, step 15 for attaching to storage
or worksurface.
*
This application requires additional support from
storage or worksurface.
ANSWER EOR
VERTICAL
JUNCTION
6
ANSWER EOR
VERTICAL JUNCTION
2
8
LOWER HOOK
BRACKET
c
(LH SHOWN)
a
b
d
3
DECORATIVE
COVER
4
b
c
a
5
9
UPPER HOOK
BRACKET
(LH SHOWN)
RECTANGULAR
BRACKET
7
Page 7 of 39
73085 Rev E