Single-Connect Single-Sided - Steelcase Answer Boundary Screens Manual De Instrucciones

®

Single-Connect Single-Sided

Installation
1.
Place boundary screen on a clean,
scratch resistant surface.
2.
Install two (2) Answer attachment clips
with four (4) flat head wood screws
(provided) per attachment clip (2a).
Install half wing bracket with ten (10) flat
head wood screws (provided) (2b).
3.
Place Answer End-Of-Run (EOR) vertical
junction over Answer attachment clips and
slide up into position.
TIP: If desired, you can add a screw
(provided) to further secure the top of the
boundary screen to the Answer EOR vertical
junction.
4.
First install (1) 1/4-20 x 1/2" pan head
screw (as shown) to determine junction
vertical alignment (4a), proceed to install
three (3) remaining pan head screws and
washers inside pocket as shown (4b).
5.
Install decorative cover as shown.
6.
Install glide as shown.
7.
Lift single-sided boundary screen
assembly up and assemble rest of Answer
panel per assembly direction # 939504607.
NOTE: If this single-sided boundary screen
has a return, go to page 6 for that
installation process.
ANSWER
ATTACHMENT CLIP
2a
ANSWER EOR
VERTICAL
JUNCTION
HALF WING
BRACKET
1/4-20 x 1/2" PAN HEAD
3
5
2b
2a
SCREW
WASHER
4b
DECORATIVE
COVER
6
2a
SEE TIP
4a
ANSWER EOR VERTICAL JUNCTION
Page 2 of 39
73085 Rev E