Uline H-2770 Manual De Instrucciones página 3

OPERATION
1. Customer takes a number from the Dispenser and
waits until the number appears on the Indicator.
2. Press (+) on the wireless push button once to display
the next number.
3. Press and hold (+) on the wireless push button to
advance the numbers by tens.
4. Use (–) on the wireless push button to go back one
number at a time.
NUMBER DISPENSER
Can be mounted to either the wall or stand.
WALL MOUNTING
1. Mark mounting holes
on wall using Dispenser
Mounting Bracket as a
template. (See Figure 1)
2. Drill holes using 3⁄16" to
5⁄16" drill bit.
3. Use wall anchors (not
included) if attaching to
surfaces other than solid
wood.
4. Position Sign and Dispenser Mounting Bracket (longer
holder at the top) over holes in wall and fasten with
two slotted screws. (See Figure 2)
5. Snap Dispenser into Mounting Bracket. (See Figure 3)
Sign
Figure 2
STAND MOUNTING
1. Position Mounting Stand in the desired location on
counter top.
FOR CLEAN, SMOOTH SURFACES: Remove backing
from adhesive strips on the base of the Mounting
Stand and secure to surface.
PAGE 3 OF 20
OPERATION
2. Align holes in Sign and Mounting Bracket (longer
3. Snap Dispenser into Mounting Bracket. (See Figure 3)
LOADING DISPENSER
1. Pull down Locking Bar to open Dispenser.
Figure 1
2. Drop in Number Roll (not included) so the numbers
Figure 3
3. Pull end of roll through end of Dispenser. Close
FOR PERMANENT MOUNTING: Using the base of
Mounting Stand as a template, mark and drill 4
holes and secure base of stand to surface with 4
screws (not included).
holder on top) with holes in post. Push two large slotted
bolts through Bracket and Sign and secure with nuts.
(See Figure 4)
Figure 4
roll out from the bottom. (See Figure 5)
Number Roll
(not included)
Locking Bar
Figure 5
Dispenser and snap Locking Bar back into place.
BOTTOM VIEW
Adhesive Strips
1015 IH-2770