Uline H-2770 Manual De Instrucciones página 4

ELECTRONIC INDICATOR
MOUNTING BRACKET TO WALL
1. Determine where to place the Indicator so it is easily
seen by customers.
2. Mark mounting holes on wall using the Indicator Wall
Mount Bracket as a template. (See Figure 6)
3. Drill holes using 5⁄16" drill bit.
4. Use wall anchors (included) if attaching to surfaces
other than solid wood.
5. Position Indicator Wall Mount Bracket over drilled
holes and fasten with two large Phillips screws.
(See Figure 7)
Figure 6
CONNECTING AC POWER SUPPLY
1. Plug the Power Connector into either of the two
power receptacles located on the back of the
Indicator. (See Figure 8)
PAGE 4 OF 20
INDICATOR - MOUNTING AND INSTALLATION
Figure 7
Power Connector
Figure 8
2. Choose correct country outlet adapter for AC
plug-in. (See Figure 9)
Adapter
AC Plug-in
3. Attach 10' power extension cable if necessary.
(See Figure 10)
Power Connector
4. Plug the Transformer into the nearest adapter plug
with correct country adapter.
CONNECTING WIRELESS RECEIVER
1. Place the pin connector of the wireless receiver on
the pins located on the back of Indicator.
(See Figure 11)
2. Remove backing from adhesive strips on the wireless
receiver and mount it on the back of the indicator.
Country Outlet Adapters
Figure 9
Power Extension Cable
Figure 10
PIN CONNECTOR
Figure 11
1015 IH-2770