Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INDICATOR - MOUNTING AND INSTALLATION CONTINUED
SET-UP
SETTING SOUND TONE AND VOLUME
Use a mini screwdriver to change the tone and volume
switches on back of the Indicator. (See Figure 12)
Set the Sound Tone with Switches 1-2:
• No Sound: SW1-OFF, SW2-OFF
• Single Tone: SW1-OFF, SW2-ON
• Double Tone: SW1-ON, SW2-OFF
• Triple Tone: SW1-ON, SW2-ON
Set the Volume with Switches 3-4:
• Low Volume: SW3-OFF, SW4-OFF
• Medium Volume: SW3-ON, SW4-OFF
(recommended in most cases)
• High Volume: SW3-OFF, SW4-ON
INDICATOR START-UP
The indicator displays a number of messages on
start-up once it is plugged in. (See Figure 13)
Indicator displays:
• Program Version: P-, then number
• TOM-Net Address: Ad, then 51
• Last Number Displayed when power was
disconnected: Number, ('00' if first-time start-up.)
• Error message if Indicator is set as a duplicate
Master: 'Ed'
PAGE 5 OF 20
Figure 12
Figure 13
INDICATOR SET-UP
(See Figure 14)
Restart the Indicator by unplugging it and plugging it
back in. Hold down (+) on the wireless push button while
the Indicator Start-up displays "RUN" to enter the set-up
options.
1. Set Indicator Update delay:
• Indicator shows 'UP' followed by the current delay
time in seconds, (ex. '00'). Press (+) on the wireless
push button to increase the delay 1 second at a
time.
• After 3 seconds without pushing the button, the Set
Indicator Sleep Time 'SL' appears.
2. Set Indicator Sleep Time
• Indicator shows 'SL' followed by the current setting in
minutes. (The Indicator shuts off after a set period of
time with no button pushes.) Press (+) on the wireless
push button to increase the delay before the
Indicator goes into sleep mode 1 minute at a time.
• After 3 seconds without pushing the button, the set
Indicator Flashes and 'FL' appears.
3. Set indicator Flashes when number changes:
• Indicator shows 'FL' followed by the current setting
showing number of flashes. Press (+) on the wireless
push button to increase the number of times the
indicator will flash when the number changes one
flash at a time.
4. After 3 seconds without pushing the button, the
indicator displays 'CS' and saves new settings to
memory.
Delay Time (seconds)
1
Sleep Time (seconds)
2
Number of Flashes (when changing)
3
4
Range: 00–29
Range: 00–99
Range: 00–09
Figure 14
1015 IH-2770
Publicidad
Tabla de contenido
