Uline H-2770 Manual De Instrucciones página 6

NOTE: The wireless push button codes must be
copied to the wireless receiver. The maximum
number of wireless push buttons per wireless
receiver is 15.
NOTE: Individual wireless push button codes
cannot be changed or deleted. All codes must
be deleted to start over with new codes.
ADDING WIRELESS PUSH BUTTON CODES
1. Press A on the wireless receiver and hold for three
seconds. The green LED light on the back of the
wireless receiver will start blinking. (See Figure 15)
2. Let go of A on the wireless receiver. Then press the
+ button on the wireless push button. The green LED
light will stop blinking. (See Figure 16)
Figure 15
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
PAGE 6 OF 20
PROGRAMMING WIRELESS REMOTE
LED
Lights
A B
1-800-295-5510
3. Press B on the wireless receiver and hold for three
seconds. The red LED light on the back of the wireless
receiver will start blinking. (See Figure 15)
4. Let go of B on the wireless receiver. Then press the –
button on the wireless push button. The red LED light
will stop blinking. (See Figure 16)
DELETING WIRELESS PUSH BUTTON CODES
1. Press A on the wireless receiver for three seconds.
Release and press A again for three seconds. The
code has been deleted. (See FIgure 15)
2. Press B on the wireless receiver for three seconds.
Release and press B again for three seconds. The
code has been deleted. (See Figure 15)
Figure 16
uline.com
1015 IH-2770