Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Checking the recovery water tank
Lift the cover (A) using its grip (B) and check that the recovery
water tank (C) is empty, otherwise empty it as described in the
specifi c "Emptying the tanks" section.
Filling the detergent solution tank with water (or
washing water)
The tank can be fi lled in one of the following ways, depending
on the inlet version fi tted on the machine.
!
WARNING!
The temperature of the water in the tank must not exceed
40°C (100°F).
!
WARNING!
Use a suitable detergent for the type of cleaning to be car-
ried out.
Only use low foam and non-fl ammable liquid detergents,
suitable for your machine.
When using detergents for cleaning fl oors, follow the in-
structions and warnings on the labels.
Use suitable gloves and protective devices before handling
fl oor cleaning detergents.
Standard inlet
•
Unscrew the cap (D) and pour water through its inlet.
•
Once the fi lling is complete, screw the cap (D).
Inlet with fi lling kit (UPON REQUEST)
•
Remove the fi lling kit (F), put the opening (G) under a
water tap and fi ll the tank through the inlet (E).
•
After the fi lling stage, place the kit (F) back in its seat.
Installing/Filling the 5-litre detergent tank ("DE-
TERSAVER" - UPON REQUEST)
(version with automatic detergent feeding system)
!
WARNING!
Use a suitable detergent for the type of cleaning to be car-
ried out.
Only use low foam and non-fl ammable liquid detergents,
suitable for your machine.
When using detergents for cleaning fl oors, follow the in-
structions and warnings on the labels. Use suitable gloves
and protective devices before handling fl oor cleaning de-
tergents.
•
Fit the tank (H) in its mount (I).
•
Connect the detergent pump tube (L) to the tank lid (M).
•
Use the elastic strap (N) to fi x the tank (H) to its mount (I).
•
Open the lid (M) and fi ll up the tank with detergent.
TANKS
B
C
G
L
H
I
24
A
D
E
F
M
N
Publicidad
Capítulos
Tabla de contenido
