Before Use; During Use - Skil 2636 Manual Original

• Permitted ambient temperature (tool/
charger/battery):
- when charging
- during operation
- during storage
ACCESSORIES
•
the tool only when original accessories
are used

BEFORE USE

• Always check that the supply voltage is
the same as the voltage indicated on the
nameplate of the charger
• Avoid damage that can be caused by
screws, nails and other elements in your
workpiece; remove them before you start
working
•
clamped with clamping devices or in a
vice is held more securely than by hand)
•
company for assistance (contact with
shock; damaging a gas line can result
in an explosion; penetrating a water
pipe will cause property damage or an
electrical shock)

DURING USE

•
(fasteners contacting a "live" wire may
make exposed metal parts of the power
tool "live" and could give the operator an
electric shock)
• In case of electrical or mechanical
tool or unplug charger from power source
EXPLANATION OF SYMBOLS ON
CHARGER
3 Read the instruction manual before use
4 Only use the charger indoors
5 Double insulation (no earth wire
required)
6 Incorrect polarity of the charger
connection could cause a hazard (only
charge the battery with the charger
0...+45°C
–20...+50°C
–20...+50°C
(a workpiece
supplied)
7 Do not dispose of the charger together
with household waste material
8 Do not dispose of the battery together
with household waste material
USE
• Charging battery 9
!
not develop its full capacity until
IMPORTANT:
- connect charger A with both wall
socket and contact B
- indicator C lights up GREEN indicating
that the battery is being charged
- during the charging procedure, the
handle of the tool warms up; this is
normal
- when the battery is fully charged,
approximately 3 hours)
- the lithium-ion battery can be charged
at any time (interrupting the charging
procedure does not damage the
battery)
- the lithium-ion battery does not have
to be empty before charging (no
cadmium batteries)
- the tool cannot be used during the
charging procedure; it is not defective
when inoperative during the charging
procedure
- if you anticipate long periods of non-
use for the tool, it is best to unplug the
charger from its power source
•
q
• Changing direction of rotation w
- when not properly set in left/right
position, switch D 2 cannot be
activated
- indicator F shows the selected
direction of rotation
!
12