Maintenance / Service - Skil 2636 Manual Original

standstill
• Changing bits e
- push bit to end position in bitholder G
!
• Automatic spindle-lock
Allows you to manually tighten or loosen
screws, when necessary r
• Spot light t
Spot light H automatically lights on when
activating switch D, even when switch E
is in the middle (locking) position
• Bit storage J 2
• Battery level indicator
When indicator C 2 lights up RED while
switch D 2 is depressed half way, then
the battery has less than 30% of its
capacity and should be charged
• Battery protection
1) the battery temperature gets too high
(> +65°C)
2) the lithium-ion battery is nearly empty
(to protect against deep discharge)
APPLICATION ADVICE
• Use the appropriate bits y
!
!
• When turning in a screw at/near the
cross cut end or an edge of wood, pre-
drill a hole in order to avoid cracking of
the wood
• For an optimal use of the tool a steady
pressure on the screw is required,
especially while removing
• When screwdriving in hard wood one
should pre-drill a hole
• For more tips see www.skil.com

MAINTENANCE / SERVICE

• This tool is not intended for professional
use
• Keep tool and charger clean
!
• If the tool/charger should fail despite the
care taken in manufacturing and testing
procedures, repair should be carried out
by an after-sales service centre for SKIL
power tools
- send the tool or charger
undismantled together with proof of
purchase to your dealer or the nearest
SKIL service station (addresses as
well as the service diagram of the tool
are listed on www.skil.com)
ENVIRONMENT
• Do not dispose of electric tools,
for EU countries)
- in observance of European Directive
2012/19/EC on waste of electric
and electronic equipment and its
implementation in accordance with
national law, electric tools that have
reached the end of their life must be
collected separately and returned to an
environmentally compatible recycling
facility
- symbol 7 will remind you of this when
the need for disposing occurs
!
• Removing/disposing of batteries u
!
are completely empty
- protect battery terminals with heavy
tape to prevent short-circuit
-
collection point for batteries
!
NOISE/VIBRATION
• Measured in accordance with EN 60745
the sound pressure level of this tool is
<70 dB(A) (standard deviation: 3 dB) and
the vibration < 2,5 m/s² (triax vector sum;
uncertainty K = 1.5 m/s²)
13
(only