Publicidad
Step 17
Before fastening the DOOR to your unit, be sure the mounting screw is against the stops as shown in the upper diagram
å
below. If it isn't, loosen the mounting screw to slide it against the stops. Then tighten the mounting screw.
DOOR OPENS LEFT: Fasten the DOOR to the EXTENSION BLOCK (P) to the left of your unit. Use the screws in the
å
hinges. You should start each SCREW a few turns before completely tightening any of them.
DOOR OPENS RIGHT: Fasten the DOOR to the EXTENSION BLOCK (P) to the right of your unit. You should start each
å
SCREW a few turns before completely tightening any of them.
Fasten the KNOB (33K) to the DOOR (H). Use a GOLD 1" MACHINE SCREW (50S).
å
Push a DOOR STOP (4I) into the SHELF (E) as shown according to your door confi guration.
å
DOOR OPENS LEFT
P
33K
H
4I
www.sauder.com/services
Stop
Mounting
screw
Hinge
E
50S
GOLD 1" MACHINE SCREW
(1 used for the KNOB)
420519
DOOR OPENS RIGHT
Stop
Mounting
screw
Hinge
E
4I
P
33K
H
Page 21
Publicidad
