Publicidad
Step 3
Fasten the HALF DISKS (T) to the COLUMN
å
MOLDINGS (Q) as shown in the upper diagram. Use
two BROWN 1" FLAT HEAD SCREWS (12S).
1. Fasten the UPPER PLINTHS (O) to the VERTICAL
å
MOLDINGS (R and S). Use two BLACK 1-1/4" FLAT
HEAD SCREWS (7S).
2. Fasten the COLUMN MOLDINGS (Q) to the
å
VERTICAL MOLDINGS (R and S). Use six BLACK 1-1/4"
FLAT HEAD SCREWS (7S).
NOTE: Do not overtighten the screws.
å
Remember:
Righty tighty.
Lefty loosey.
BLACK 1-1/4" FLAT HEAD SCREW
These edges
must be even.
st
1
O
T
2
Curved edge
www.sauder.com/services
7S
(8 used in this step)
S
nd
Q
BROWN 1" FLAT HEAD SCREW
(2 used in this step)
The large
hole should
be facing up.
Q
These edges
must be even.
420519
12S
The large
T
T
hole should
be facing up.
Q
O
st
1
Curved edge
T
nd
2
R
Q
These edges will
have 1/2" off set.
Page 7
Publicidad
