Sony BKM-37H Manual De Instrucciones página 21

10
Plug the connecting cable into the DC 5V OUT and
LAN (10/100) connectors at the side of the monitor.
Note
Be sure to plug the male connector of the cable into the
DC 5V OUT connector on the monitor.
Plug the male
connector into
the DC 5V OUT
on the monitor.
For other monitors
1
Remove the five legs from the bottom of the control
unit and attach the left and right stands to the sides of
the control unit.
See steps 1 and 2 of - "For BVM-L/PVM-L series
monitors" (page 18).
2
Remove the four legs from the bottom of the monitor
and the screws on the left and right sides from the rear
of the monitor.
Rear of the monitor
3
Place the rear stay on the monitor and assemble using
two screws B (4 × 8).
DC 5V OUT
connector
LAN (10/100)
connector
4
Place the monitor on the control unit with the stands
attached. Attach the monitor to the stands using four
screws B (4 × 8), adjusting the positions of the screw
holes of the rear stays and control unit.
Place the protrusion of the control unit into the hole of
the rear stay as shown.
Protrusion
Screw B
Control unit
Stand (right)
Rear stay
Screw B
21
Assembly