Publicidad
Idiomas disponibles
Idiomas disponibles
Top mount Curved
Shaft Trimmer
INSTALLING CURVE SHAFT TO THE POWER HEAD
1. Unplug the power head.
2.Loosen the knob on the coupler and remove the
hanger cap from the attachment.
3.Push in the button located on the attachment
shaft. Align the button with the guide recess on
the power head coupler and slide the two shafts
together. Rotate the attachment shaft until the
button locks into the positioning hole.
ATTACHING THE FRONT HANDLE
1. Unplug the power head.
2. Press the front handle onto the power head shaft
so that the handle is angled toward the rear handle.
3. Place the front handle along the power head shaft
to a position that allows for comfortable operation.
4. Slide the bolt through the holes in the front handle.
5. Slide the washer onto the bolt.
6. Place the wing nut onto the bolt and tighten the
wing nut securely.
ATTACHING THE GRASS DEFLECTOR
1. Slide the guard on to the shaft, aligning the guard
holes with the holes on the lower shaft.
2. Slide the bolt through the guard and lower shaft.
3. Take the nut and secure it on the bolt clockwise.
4. Ensure that the nut is securely fastened to the
shaft and guard before using the trimmer.
CONNECTING TO POWER SUPPLY
The power head is designed with a cord retainer that
prevents the extension cord from being pulled loose
while using.
• Form a loop with the end of the extension cord.
• Insert loop portion of extension cord through opening
in the bottom of the rear handle and place over cord
retainer.
• Slowly pull loop against cord retainer until the slack
is removed.
• Plug power head into extension cord.
STARTING AND STOPPING THE POWER HEAD
1.To start the power head: Depress the lock-out button
and squeeze the switch trigger.
2.To stop the power head: Release the switch trigger.
GETTING STARTED
BUTTON
CURVE SHAFT ATTACHMENT
FRONT HANDLE
POWER HEAD SHAFT
KNOB
BOLT
WASHER
LOCK-OUT BUTTON
SWITCH TRIGGER
2101000
WING NUT
Publicidad
