Electrical Connection - Franke FH FS 864 Manual De Instalación

EN
Basic adjustment of sensors to the ambience
Upon each connection to the power supply the sensors of the appliance are
automatically adjusted to the environment to ensure their proper function. All
displays turn on and are fully illuminated for a few seconds.
During the adjustment procedure the sensors must be free of any objects, otherwise
the adjustment procedure will be interrupted until such objects are removed from
the sensor surface. During this period the regulation of the cooktop is impossible.

Electrical connection

Connection terminals are revealed when the connection box cover is removed.
FRANKE hobs are supplied with a power cable.
Make sure the characteristics of the household electrical system (voltage,
X X
maximum power and current) are compatible with those of the appliance.
If the appliance is to be permanently connected to the power supply:
Install a device that enables disconnection from the power supply, with a contact
X X
opening distance (3 mm) that ensures complete disconnection in category III
overvoltage conditions.
Ensure the following:
X X
– The plug and socket are suitable for a 16 A current.
– The plug and the socket can be easily reached and are positioned so that no live
part is accessible when inserting or removing the plug.
– The appliance does not rest against the plug when installed in the worktop.
– A 5 x 2.5 mm
– The earthing wire must be connected to the terminal marked with the earthing
symbol.
– The connection cable must lead through the relief safety device, protecting it
from accidental pulling out.
After electrical connection
Switch on all the hotplates for about 3 minutes to check the proper function.
X X
FH FS 865 / FH FS 864 / FH FS 784 / FH FS 584
H05 V2V2-F type cable is used when replacing the power cable.
2
– 10 –