Eco Mode" Saving Function; Restarting After A Power Failure; Lock Keypad" Function; Frost Protection Function - Palazzetti WILMA Manual De Uso

4.2 "ECO MODE" SAVING FUNCTION

Enabling this function means that the stove switches off when reaching the desired room temperature. If
this function is not enabled, the stove modulates operation so as to maintain the desired temperature while
consuming the least amount of fuel possible. The "Eco Mode" function is only available in con guration 2.
To enable/disable the function:
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Select submenu
d) Set one of the following values using the
Eco Enable "Eco Mode" function
Off Disable "Eco Mode" funcition
e) Press to con rm the settings.

4.3 RESTARTING AFTER A POWER FAILURE

In the event of power failures, the stove will switch back on automatically, checking the safety conditions, when
power returns.

4.4 "LOCK KEYPAD" FUNCTION

This function is used to disable the use of the control panel and avoid accidental modi cations.
To enable/disable the function:
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Select submenu
d) Use the
" Lock keypad disabled
Off
"
"Lo" Only the on/off button
Lock keypad enabled
Hi
" "
e) Press to con rm the settings.

4.5 FROST PROTECTION FUNCTION

In con gurations 2, 3 and 4 a minimum temperature can be set below which the boiler will switch on (outside of
the set time bands).
To set the "frost protection" temperature:
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Select submenu
d) The value will ash; change it using the
e) Press to con rm the settings.
Con guration 3 and 4:
To set the "frost protection" temperature:
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Select submenu
d) The value will ash; change it using the
e) Press to con rm the settings.
Setting the value to "OFF" in step d disables the function.
to go to the setup menu
and con rm by pressing
[7]
to go to the setup menu
[10] and con rm by pressing
buttons to set one of the following values:
is enabled
to go to the setup menu
[9] and con rm by pressing
to go to the setup menu
and con rm by pressing
[9]
and then press
to con rm;
.
buttons:
and then press
to con rm;
.
and then press
to con rm;
;
buttons ( OFF ; 3...20 C);
and then press
to con rm;
;
buttons ( ; C);
OFF 3...50
;
;
;
;
25