Startup And Shutdown; Startup; Shutdown; Importing And Exporting Cartridges - Sony ODS-L30M Manual De Instrucciones

Startup and Shutdown

Note
Always close the I/E station when starting and shutting
down the unit.

Startup

1
Check that the power cord is connected, and then turn
on the main power switch on the rear panel of the unit.
2
Press the on/standby button on the front panel.
When you press the button, the on/standby indicator
lights green.
Initialization will end, and the unit will be ready for
use when the text on the display stops blinking.

Shutdown

1
Press the on/standby button.
2
When the shutdown confirmation message appears on
the display, use the arrow buttons to select [Yes], and
then press the ENTER button.
Another confirmation message appears if there is a
cartridge in any of the drives.
3
Wait until the on/standby indicator changes from
blinking green to lit in red, and then turn off the main
power switch on the rear panel.
46
Startup and Shutdown / Importing and Exporting Cartridges
Importing and Exporting
Cartridges

Opening the I/E Station

Press the I/E STATION button on the front panel to release
the I/E station lock before opening the I/E station. When
you press the I/E STATION button, the lock releases and
the I/E STATION indicator blinks orange.
Notes
• Press and hold the I/E STATION button (for about one
second) and wait until the I/E STATION indicator blinks
orange before opening the I/E station.
• If the I/E station does not unlock when the I/E STATION
button is pressed, push the I/E station all the way into the
unit and then press the I/E STATION button again.

Importing and Exporting a Cartridge

Insert a cartridge into a slot, and push the cartridge all the
way in until it stops.
Label attachment area facing forward.
When removing a cartridge, pull the cartridge out to the
left while keeping it horizontal.
Closing the I/E station
Slowly push the I/E station all the way into the unit, and
check that the I/E STATION indicator blinks green.
Notes
• If the I/E STATION indicator is blinking orange, the I/E
station is not completely closed.
• A warning tone sounds if the I/E station is left open for
3 minutes or longer.