Menu List - Sony ODS-L30M Manual De Instrucciones

6
Use the J and j buttons to move the cursor (>).
Control Panel
7
Press the ENTER button to confirm the setting.
The cursor disappears, and the setting is confirmed.
8
Press the MENU button to return to the menu selection
screen (step 1).
Pressing the BACK button returns to the immediately
preceding screen.
9
Press the MENU button again to end menu operation.

Menu List

Menu
Information
Setup
52
Menu Operation
Description
Displays the current values of
each setting in the [Setup] menu
and the following IPv6
parameters.
IPv6 Temporary: Displays the
IPv6 temporary address.
IPv6 Link-Local: Displays the
IPv6 link-local address.
Allows you to configure the unit's
settings.
Menu Description
1.Network Configures the network settings.
Network 1 / Network 2:
IPv4 Enabled / IPv6 Enabled:
IPv4 DHCP / IPv6 DHCP:
IPv4 Address / IPv6 Address:
IPv4 Netmask: Configures the
IPv6 Subnetprefix: Configures
IPv4 Gateway / IPv6 Gateway:
IPv4 DNS / IPv6 DNS: Specifies
IPv4 Primary DNS / IPv6
IPv4 Secondary DNS / IPv6
2.Control Panel Configures the control panel
settings.
Buzzer: Turns the warning tone
LCD Backlight: Specifies
LCD Brightness: Sets the LCD
Maintenance Menu used for maintenance.
1.Configuration Factory Setting: Restores the
2.Diagnostic Menu for service personnel.
3.Power Management Reboot: Restarts the unit.
4.Service Menu for service personnel.
Configures settings for the
ODS-L30M's two network
ports.
Enables or disables IPv4 or
IPv6.
Specifies whether to use the
DHCP for the IPv4 or IPv6 IP
address or whether to use a
static address.
Configures the IPv4 or IPv6
IP address.
IPv4 subnet mask.
the IPv6 subnet prefix.
Configures the IPv4 and IPv6
default gateway.
whether to obtain the IPv4 or
IPv6 IP DNS automatically or
whether to use a static
address.
Primary DNS: Configures the
IPv4 and IPv6 primary DNS.
Secondary DNS: Configures
the IPv4 and IPv6 secondary
DNS.
on or off.
whether the LCD backlight
turns off automatically or
whether it is always on.
brightness to Low, Middle, or
High.
unit's configurations to their
factory default settings.