Location Requirements; Front View; Side View - Alliance Laundry Systems LES33A Instrucciones De Instalación

Location Requirements . . .

Select a location with a solid floor.
No other fuel burning appliance should be installed in
the same closet with the dryer.
The dryer must not be installed or stored in an area
where it will be exposed to water and/or weather.
Leveling legs can be adjusted from inside the dryer
with a 1/4" driver. All four legs must rest firmly on the
B
A A

FRONT VIEW

(w/o Closet Door)
AREA DESCRIPTION
A Dryer sides and rear clearance
B Dryer top clearance
C Dryer front clearance
D Exhaust duct clearance to
combustible material
E Weather hood to ground clearance
F Distance from floor or ceiling to
hole edge
G* Area of centered air openings in
closet door
*Louvered door with equivalent air openings is acceptable. (Minimum clearances are shown.)
** NOTE: For new installations, locate top of wall vent 42 inches above floor to make venting easier to
connect.
504607
floor so the weight of the dryer is evenly distributed.
The dryer must not rock.
The dryer needs sufficient clearance and an adequate
air supply for proper operation and ventilation, and for
easier installation and servicing. (Minimum clearances
are shown below.)
CLOSET
DOOR
D
A
C

SIDE VIEW

FREE STANDING / ALCOVE
INSTALLATION
(See Illustration)
0" (0 cm)
12" (30.5 cm)
Not Applicable
2" (5.1 cm)
12" (30.5 cm)
Not Applicable
Not Applicable
CENTERED
OPENINGS (G)
E
(2 Openings
Minimum)
**42"
FRONT VIEW
OUTER
WALL OF
(Closet Door)
ENCLOSURE
CLOSET INSTALLATION
(See Illustration)
0" (0 cm)
12" (30.5 cm)
2" (5.1 cm)
2" (5.1 cm)
12" (30.5 cm)
3" (7.6 cm)
40 sq. in./open (260 sq. cm)
F
AIR
F
D317IE3C
17