Location Requirements; Front View; Side View - Alliance Laundry Systems 505048R2 Manual De Instalación Y Operación

Location Requirements . . .

Select a location with a solid floor.
No other fuel burning appliance should be installed in the
same closet with the dryer.
The dryer must not be installed or stored in an area where
it will be exposed to water and/or weather.
Leveling legs can be adjusted from inside the dryer with
B

FRONT VIEW

(w/o Closet Door)
(Minimum clearances are shown.)
** NOTE: For new installations, locate top of wall vent 42 inches (107 cm) above floor to make venting
easier to connect.
24
A A
AREA DESCRIPTION
A Dryer sides and rear clearance
B Dryer top clearance
C Dryer front clearance
D Exhaust duct clearance to
combustible material
E Weather hood to ground
clearance
a 1/4" driver. All four legs must rest firmly on the floor so
the weight of the dryer is evenly distributed. The dryer
must not rock.
The dryer needs sufficient clearance and an adequate air
supply for proper operation and ventilation, and for easier
installation and servicing. (Minimum clearances are
shown below.)
A
C

SIDE VIEW

FREE STANDING /
ALCOVE INSTALLATION
(See Illustration)
0" (0 cm)
12" (30.5 cm)
Not Applicable
2" (5.1 cm)
12" (30.5 cm)
E
D
**42"
(107 cm)
D366IE3B
OUTER
WALL OF
ENCLOSURE
505048