Publicidad
Idiomas disponibles
Idiomas disponibles
If necessary, the toe protector's
position can be adjusted or it can be
removed completely.
• (Fig. 5) Now place the loose front shin
onto the patient's shinbone and foot.
Make sure that the pump and
ventilator fit into the spaces provided.
• (Fig. 6) Close the belts to stabilise the
system. Start by closing the belt at the
front and then close all the other belts
one after another. The belts should fit
tightly.
Extra material can be cut away.
• Ask the patient to walk around in the
orthosis to make sure that the Walker
is sitting properly.
• (Fig. 7) To tighten the Walker's fit, the
air cushions can be filled using the
pump system. Adding or letting out air
can be operated using the valve. The
padded pieces can be used as
additional padding.
Care instructions
Hook and loop fasteners should be
closed for washing. Soap residues,
lotions and ointments can cause skin
irritation and material wear.
• Wash the product by hand, preferably
using medi clean washing agent.
• Do not bleach.
• Leave to dry naturally.
• Do not iron.
• Do not dry clean.
Storage instructions
Keep the product in a dry place and do
not expose to direct sunlight.
Material Composition
PP, PU, EVA, Polyester
Liability
The manufacturer's liability will become
void if the product is not used as
intended. Please also refer to the
corresponding safety information and
instructions in this manual.
Disposal
The product can be disposed of
in the domestic waste.
In the event of any complaints regarding
the product such as damage to the fabric
or a fault in the fit, please report to your
specialist medical retailer directly. Only
serious incidents which could lead to a
significant deterioration in health or to
death are to be reported to the
manufacturer or the relevant authorities
in the EU member state. The criteria for
serious incidents are defined in Section
2, No. 65 of the Regulation (EU) 2017/745
(MDR). The traceability of this product is
assured via a UDI code
English
.
Publicidad
