Operation; Synchronising Transmitter / Receiver - Silvercrest HG01041A Instrucciones De Montaje, De Uso Y De Seguridad

Close the battery compartment
Transmitter:
Remove the holder
Open the battery compartment
cover anticlockwise.
Insert a battery (3 V
marked "+" must face upwards.
Place the battery compartment cover on the battery compartment
and tighten it by turning it clockwise.
Fasten the holder
transmitter.

Operation

Synchronising transmitter / receiver

Synchronise the transmitter and receiver as follows:
Press the synchronisation button
Press the chime button
programmed audible signal sounds and the signal indicator
ceases to illuminate when
selected by the signal type selector sliding switch
If the receiver does not react as described, press the synchronisation
button
2
repeat the synchronisation process.
from the back of the transmitter.
14
(direct current), type CR 2032). The side
of the transmitter back on to the back of the
14
; the signal indicator
12
,
again to switch off the synchronisation function and
.
9
by turning the battery compartment
13
.
2
optical and acoustic signal is
flashes red. The
1
1
.
5
GB/IE 27
13