DeWalt DW007 Manual De Instrucciones página 15

394154-00,00,DW007 bc 5/13/02 8:54 AM Page 12
pieces don't hang up on inside of lower guard.
When ripping (cutting with the grain) the use of a rip fence is
recommended.
POCKET CUTTING
DISCONNECT TOOL FROM POWER SUPPLY WHEN MAKING
THIS OR ANY OTHER ADJUSTMENT. Adjust saw shoe so blade cuts
at desired depth. Tilt saw forward and rest front of the shoe on material
to be cut. Using the retracting lever, retract blade guard to an open
position. Lower rear of shoe until blade teeth almost touch cutting line.
Now release the blade guard (its contact with the work will keep it in
position to open freely as you start the cut) (Figure 14). Start the motor
and gradually lower the saw until its shoe rests flat on the material to
be cut. Advance saw along the cutting line until cut is completed.
Release trigger and allow blade to stop completely before withdrawing
the blade from the material. When starting each new cut, repeat as
above. Never tie the blade guard in a raised position.
Maintenance
CLEANING AND LUBRICATION
Use only mild soap and a damp cloth to clean the tool. Many
household cleaners contain chemicals which could seriously damage
plastic. Also, do not use gasoline, turpentine, lacquer or paint thinner,
dry cleaning fluids or similar products. Never let any liquid get inside
the tool; never immerse any part of the tool into a liquid.
Self lubricating ball and roller bearings are used in the tool and
relubrication is not required. However, it is recommended that, once
a year, you take or send the tool to a service center for a thorough
cleaning, inspection and lubrication of the gear case.
Accessories
Recommended accessories for use with your tool are available at extra
cost from your local service center.
If you need any assistance in locating any accessory, please contact
D WALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD
E
21286 or call 1-800-732-4441.
CAUTION: The use of any other accessory or attachment may be
hazardous. Water feed attachments are not recommended for use
with this tool.
Important
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and replacement) should
be performed by authorized service centers or other qualified service
organizations, always using identical replacement parts.
Full Warranty
D WALT heavy duty industrial tools are warranted for one year from
E
date of purchase. We will repair, without charge, any defects due to
faulty materials or workmanship. For warranty repair information, call
1-800-4-D WALT. This warranty does not apply to accessories or
E
damage caused where repairs have been made or attempted by
others. This warranty gives you specific legal rights and you may have
other rights which vary in certain states or provinces.
In addition to the warranty, D
E
30 DAY NO RISK SATISFACTION GUARANTEE
If you are not completely satisfied with the performance of your
D WALT heavy duty industrial tool, simply return it to the participating
E
seller within 30 days for a full refund. Please return the complete unit,
transportation prepaid. Proof of purchase may be required.
FREE WARNING LABEL REPLACEMENT: If your warning labels
become illegible or are missing, call 1-800-4-DEWALT for a free
replacement.
12
WALT tools are covered by our: