User Calibration; Hold Function - gefran 40T 48 Manual De Instrucciones

Protection
Pr code
+4 to disable In and Ou pages
+8 to disable CF and Sr pages
+16 to enable maintenance of reset latch at power-off (for linear inputs only)
+32 base configuration (the following parameters will not be displayed):
In: F.t, F.d, oF., L.L, H.L
Ou: On [forced to no. outputs present], rE)
F.t, F.d, oF., remain at set value
L.L, H.L are forced to L.S, H.S
+64 Management of virtual instrument
+128 Disabilitazione of all the menu except PA (Password)
• Custom linearization
Ln
Custom linearization
of main input
Step 0
0. 0 .
(beginning of scale
value)
the n step value corresponds to input::
.......
mV beginning scale + n * ∆mV
∆mV = (mV full scale - mV beginning scale) / 32
3. 2 .
Step 32
(full scale value)
3. 3 .
Step 33
3. 4 .
Step 34
3. 5 .
Step 35
(*) sonly for CPU, TC_LIN e tP = TC CUSTOM
The input value and alarms remain "frozen" for the interval in which the logic input is active.
With the input active, a reset of the alarm memory provokes de-energizing of all the energized relays and resetting of the
memory of all the alarms.
Input value is sampled; state of alarms is not transferred to outputs; outputs are "frozen".
When the logic input is active the input value is "frozen" and the outputs are updated according to the calculated alarms
state, including the ones latched.
• Protection
Value Displayed Modifiable
parameters parameters
0 o.1, o.2, o.3, o.4 o.1, o.2, o.3, o.4
1 o.1, o.2 o.1, o.2
2 o.1
3 o.1
Display limits
(-1999...9999)
Display limits
(-1999...9999)
mV beginning of
(*)
scale
(*)
mV full scale
(*)
mV at 50°C

• HOLD function

• FLASH function
o.1
none

• User calibration

U.C. CPU T function
u(.
1 analog retransmission output
2 Custom RTD sensor
3 Custom PTC sensor
4 Custom NTC sensor
5 Potentiometer (0 to 1V)
Calibration of
(. L .
minimum (*)
Calibration of
(. x .
maximum (*)
15
(*) when U.C. = 1 press keys ∆
calibrate analog output
to