Bosch HND 300 Manual Del Usuario página 8

HND 300| User Manual
 Switching On and Off
To switch on the inspection camera, press the On/Off button 3. The start screen will be shown on the display 9 for a short time. To
switch off the inspection camera, press the On/Off button 3 again.
If no button on the inspection camera is pressed, it will automatically switch itself off when the set duration (k) has expired.
 Regulating the Illumination Light in the Camera Head
To brighten the camera image, you can switch on the illumination light 15 in the camera head and adjust the brightness. The
brightness can be adjusted in 4 stages (0%, 25%, 50%, 100%).
To switch on the camera illumination light 15 and to increase the brightness, press button 7 repeatedly until the required
brightness is reached.
Note: Do not stare into the illumination light 15 and do not direct it at other persons. The brightness of the light can blind the eyes.
To reduce the brightness and to switch off the camera illumination light 15, press button 7 repeatedly until the required brightness
is reached or the illumination light is switched off.
 Magnifying the Image on the Display (Zoom)
Briefly pressing button 2 magnifies the image on the display by a factor of 1.5 or 2.
 Rotating the Image on the Display (Up is Up
Use button 5 to turn the image so that "up" is also shown as up on the display.
Note: Restricted function when mirror 25 is mounted and/or when camera cable 13 is aligned vertically.
 Taking Photos/Videos
Use button 8 to switch between photo or video mode. The currently selected capture mode a is shown in the status bar b.
Use button 6 to take a photo or to start/stop video capture in the corresponding mode.
 Gallery Mode/Settings Mode
Pressing button 4 assigns a different function to buttons 8, 7, 5 and 4 (according to the representation above them on the display)
nd
(2 level). Use these buttons according to the representation on the display.
Briefly pressing button 4 opens the Gallery Mode. Press button 4 to view the image in full-screen mode and press button 6 to play
a video.
Holding down button 4 opens the Setting
Mode. The following settings are possible:
- Color rendering (red dot)/black-and-white
rendering (green dot)(h)
- Brightness of the display (i)
- Date/time (j)
- Auto-Off function: duration of inactivity of
the inspection camera after which it
switches itself off (k)
- Lighting duration of the display (l)
- Storage occupancy/formatting of the micro
SD card (m)
 Status Bar
The status bar (b) is shown on the display for
approx. 2 seconds after every button press. It
shows:
- The selected capture mode (a)
- The date and time
- The selected magnification (c)
- The selected brightness (d)
- The charge condition of the batteries (e)
 Transferring Images and Videos
Transferring images and videos is only possible
when a micro SD card 20 has been inserted.
The inspection camera can be connected to a computer using a micro USB cable 19 to transfer images and videos.
A symbol on the display indicates that the inspection camera is connected to a computer.
Data subject to change without notice
TM
)(See figure E)
8 | 20