Initial Operation - Bosch HND 300 Manual Del Usuario

HND 300| User Manual
Assembly
Power Supply (see figure A)
 To open the battery lid 17, press the unlocking buttons 18 and remove the battery lid. When inserting batteries, pay attention to
the correct polarity. Mount the battery lid 17 again until you feel it engage.
 Always replace all batteries at the same time.
 Only use batteries from one brand and with the identical capacity.
 Remove the batteries from the inspection camera when not using it for a prolonged period of time. The batteries can corrode and
self-discharge during prolonged storage.
 The symbol
will initially appear on the display if the charge condition of the batteries is low. When the symbol is empty, you
have to replace the batteries.
Camera Cable
 For the operation of the inspection camera, the camera cable 13 must be mounted to the hand unit 1. Attach the plug of the
camera cable 13 to the camera connection 21 in the correct position until it engages. See figure B
 To remove the camera cable 13, press the lock 22 together and pull the plug out of the hand unit 1. See figure C
 The mirror 25, the magnet 23 and the hook 24 can be mounted to the camera head 14 as auxiliary aids. Slide one of the three
auxiliary aids to the stop onto the recess on the camera head 14 as shown in figure D.
Note: The magnet 23 and the hook 24 are only suitable for moving and removing loose, small and light objects. Applying too much
tension can damage the inspection camera or the auxiliary aid.
Operation
 Keep the hand unit 1 dry and protected from direct sunlight. The camera cable and camera head are waterproof when mounted
correctly. However, the hand unit and battery cover are not protected against water. If they come in contact with water, there is a
risk of electric shock or damage.
 Do not subject the inspection camera to
extreme temperatures or variations in
temperature. As an example, do not
leave it in vehicles for longer periods. In
case of large variations in temperature,
allow the inspection camera to adjust to
the ambient temperature before putting
it into operation.
 Do not use the inspection camera when
the lens on the camera head 14 is misty
or fogged-up. Do not switch the
inspection camera on until after the
moisture has evaporated. Otherwise,
the inspection camera can become
damaged.
 The switched-on illumination light 15
can become hot during operation. To
prevent burns, do not touch the
illumination light.

Initial Operation

 Inserting the Micro SD Card
Open the upper cover 10 and slide the
micro SD card 20 all the way into the
slot 11. Close the upper cover again.
Data subject to change without notice
7 | 20