Description Of Symbols; General Safety - Silverline 441563 Manual Del Usuario

GB

Description of Symbols

The rating plate on your tool may show symbols. These
represent important information about the product or
instructions on its use.
Wear hearing protection.
Wear eye protection.
Wear breathing protection.
Wear head protection.
Wear hand protection.
Read Instruction Manual.
Class I construction (Protective earth)
Conforms to relevant legislation and safety standards.
Environmental Protection
Waste electrical products should not be disposed of
with household waste. Please recycle where facilities
exist. Check with your local authority or retailer for
recycling advice.
Specification
Voltage .................................................230V~
Frequency ............................................50Hz
Motor ...................................................350W
No load speed ......................................1450min
Throat depth ........................................190mm
Saw blade length .................................1425mm
Cutting capacity ...................................80mm
Sound pressure ....................................86.3dBA
Sound power ........................................99.3dBA
Protection class ....................................
The sound intensity level for the operator may exceed
85dB(A) and sound protection measures are necessary.
As part of our ongoing product development, specifications
of Silverline products may alter without notice.

General Safety

Carefully read and understand this manual and any label
attached to the tool before use. Keep these instructions with
the product for future reference. Ensure all persons who use
this product are fully acquainted with this manual.
Even when used as prescribed it is not possible to eliminate all
residual risk factors. Use with caution. If you are at all unsure
of the correct and safe manner in which to use this tool, do not
attempt to use it.
4
Keep guards in position
• Always keep guards in position, in good working order,
correctly adjusted and aligned. Never attempt to use a tool
if any of the supplied guards are missing. If any guards are
damaged, replace before use.
Remove adjusting keys
• Always check to see that keys and adjusting devices are
removed from the tool before use.
Clean the work area
• Accidents can occur where benches and work areas are
cluttered or dirty, floors must be kept clear, avoid working
where the floor is slippery. If working outdoors, make
yourself aware of all potential slip and trip hazards before
using this tool.
Children and pets
• Children and pets should always be kept at a safe distance
from your work area. Lock tools away where children can't
get access to them. Do not allow children or untrained
persons to use this tool.
Use the correct tool
• Do not force, or attempt to use a tool for a purpose it was
not designed.
• This tool is not intended for industrial use.
Wear suitable clothing and footwear
• Do not wear loose fitting clothing, neckties, jewellery, or other
items which may become caught. Wear non slip footwear, or
footwear with protective toe caps where appropriate. Long
hair should be covered or tied back.
Keep your balance
• Do not over reach, keep proper footing at all times, do not
use tools when standing on an unstable surface.
Accessories
-1
• The use of any attachment or accessory other than those
mentioned in this manual could result in damage or injury.
The use of improper accessories could be dangerous, and
may invalidate your warranty.
Secure work
• Where possible, always secure work. If appropriate use a
clamp or vice, it will allow you to use both hands to operate
your tool.
Check for damaged or missing parts
• Before each use, check if any part of the tool is damaged
or missing, check carefully that it will operate properly and
perform its intended function. Check alignment of moving
parts for binding. Any guard or other part that is damaged
should be immediately repaired or replaced by an authorised
service centre. DO NOT USE IF DEFECTIVE.