Cleaning The Multi-Surface Brush-Roll; Cleaning The Sensors And Charging Pads; Cleaning The Side Brushes - Shark ION ROBOT RV750EU Instrucciones

MAINTENANCE

CLEANING THE MULTI-SURFACE BRUSH-ROLL

The brush-roll needs occasional maintenance.
Replace brush-roll when visibly worn. See sharkclean.eu for replacement parts.
Push up on the tabs on the brush-roll access door,
then lift off the door.
Remove the blue cap on the end of the brush-roll.
Do not let the metal cylinder inside the cap fall out.
Clean off any hair or debris, then replace cap. Clean
the brush-roll whenever hair appears.
NOTE: If the metal cylinder falls out of the brush-roll cap, reinsert it in the hole on the inside of the cap.
When cutting away debris, be sure not to cut the brush-roll or any other parts of the Robot
20
sha rkclean.eu
Lift out the brush-roll.
Reinstall the brush-roll, inserting the flat end first.
Close the brush-roll access door and press down
until it clicks into place.
MAINTENANCE

CLEANING THE SENSORS AND CHARGING PADS

CLEAN SENSORS AND CHARGING PADS AS NEEDED. Clean with a dry cloth or cleaning brush.
Gently dust off the sensors and pads located on the bottom of the Robot.
IMPORTANT: The Robot uses cliff sensors to avoid stairs and other steep drops. Sensors may work less
effectively when they are dirty. For best results, clean sensors regularly.

CLEANING THE SIDE BRUSHES

NOTE: Remove any side brushes that are bent or damaged. To remove a brush, lift it off its peg. See
Installing the Side Brushes for instructions on how to attach and remove the brushes.
NOTE: Cloth is not included
Carefully unwind and remove any string or hair
wrapped around brushes.
Gently wipe brushes with a damp cloth.
s h a r kc l e a n . e u
21