Assembly And Adjustments - DeWalt DC411 Manual De Instrucciones

• Only fit 13 Amperes BS1363A approved
plugs fitted with the correctly rated fuse
(1).
• The cable wire colours, or a letter, will be
marked at the connection points of most
good quality plugs. Attach the wires to
their respective points in the plug (see
below). Brown is for Live (L) (2) and Blue
is for Neutral (N) (4).
• Before replacing the top cover of the
mains plug ensure that the cable restraint
(3) is holding the outer sheath of the cable
firmly and that the two leads are correctly
fixed at the terminals crews.
4
3
WARNING: NEVER use a light socket.
NEVER connect the live (L) or
neutral (N) wires to the earth
pin marked E or
Using an extension cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see technical data). The minimum conductor size is
1 mm 2 ; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.

ASSEMBLY AND ADJUSTMENTS

WARNING: Prior to assembly and
adjustment, always remove the battery
pack. Always switch off the tool before
inserting or removing the battery pack.
WARNING: Use only D
packs and chargers.
Inserting and removing the
battery pack into the tool (fi g. 2)
WARNING: To reduce the risk of
serious personal injury, turn tool off
TO INSTALL THE BATTERY PACK INTO THE TOOL HANDLE
1. Align the base of the tool with the notch inside
2. Slide the battery pack firmly into the handle until
TO REMOVE THE BATTERY PACK FROM THE TOOL
1. Press the release buttons (k) and firmly pull the
2. Insert battery pack into the charger as
Attaching Side Handle
1
The side handle (e) can be fitted to either side of the
gear case in the threaded holes. Before using the
2
tool, check that the handle is tightened se cure ly.
To improve user comfort, the gear case will rotate
90˚ for cutting operations.
Rotating the Gear Case (fi g. 4)
.
1. Remove the four corner screws attaching the
2. Without separating the gear case from motor
NOTE: If the gear case and motor housing become
separated by more than 3.17 mm (1/8"), the tool
must be serviced and re-assembled by a D
service center. Failure to have the tool serviced may
cause brush, motor and bearing failure.
3. Re-install screws to attach the gear case to
Mounting Guard
WALT battery
E
MOUNTING AND REMOVING GUARD (FIG. 5)
and disconnect battery pack before
making any adjustments or removing/
installing attachments or accessories.
An accidental start-up can cause injury.
the tool's handle (fig. 2).
you hear the lock snap into place.
battery pack out of the tool handle.
described in the charger section of this manual.
WARNING: To reduce the risk of
serious personal injury, turn tool
off and remove battery pack before
making any adjustments or removing/
installing attachments or accessories.
gear case to motor housing.
housing, rotate the gear case head to desired
position.
the motor housing. Tighten screws to 2.2 Nm
(20 in-lbs.) torque. Overtightening could cause
screws to strip.
WARNING: To reduce the risk of
serious personal injury, turn tool
off and remove battery pack before
making any adjustments or removing/
installing attachments or accessories.
E NG L IS H
WALT
E
45