Iso Ddin Radio Provision - Metra 99-7613 Instrucciones De Instalación

ISO DDIN radio provision

1. Remove the brackets from the
factory radio.
2. Secure the brackets to the
aftermarket radio using the screws
supplied with the aftermarket
radio. (Figure A)
Note: The 99-7613 brackets can
be used in place of the factory
brackets. Refer to previous page
for tab instructions.
3. Locate the factory wiring harness
and antenna connector in the dash.
Metra recommends using the
proper mating adapters from Metra
and/or AXXESS.
4. Place the ISO DDIN trimplate on
the front of the radio. (Figure B)
5. Reassemble the dash in reverse
order of disassembly.
Kit Assembly
(Figure A)
99-7613
(Figure B)
7