ISO DDIN radio provision
1. Slide the radio into the bracket/radio housing
assembly, and then secure using the screws
supplied with the radio. (Figure A)
2. Locate the factory wiring harness and antenna
connector in the dash and complete all
necessary connections to the radio. Metra
recommends using the proper mating adapter
from Metra and/or AXXESS. Test the radio for
proper operation.
3. Reassemble the dash in reverse order of
disassembly.
METRA. The World's best kits.
Installation instructions for part 95-2005B
Kit Assembly
(Figure A)
™
metraonline.com
IMPORTANT
If you are having difficulties with the
installation of this product, please call our
Tech Support line at 1-800-253-TECH.
Before doing so, look over the instructions a
second time, and make sure the installation
was performed exactly as the instructions
are stated. Please have the vehicle apart
and ready to perform troubleshooting steps
before calling.
K
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
© COPYRIGHT 2004-2016 METRA ELECTRONICS CORPORATION
P
OWER