Charger Display Module (Cdm); General Display Information; Display Text Orientation - Motorola IMPRES NNTN7063 Guia Del Usuario

09L67_IMPRES_MUC.book Page 12 Tuesday, December 29, 2015 11:43 AM

CHARGER DISPLAY MODULE (CDM)

The IMPRES Adaptive Multi-Unit Charger can be enhanced with the
addition of a charger display module (CDM). For chargers with
software version 1.3 or later, order and install Motorola part number
RLN5382. For chargers with software versions 1.2 or earlier and/or
non-marked labels, which require a flash upgrade, send the charger to
the Motorola Service Center to perform the upgrade and install the
CDM (part number RLN5382).

General Display Information

The IMPRES Adaptive Multi-Unit Charger with CDM provides the user
with valuable information while performing battery maintenance and
care. The information that the charger displays and the corresponding
LED indicators are detailed in the following tables.

Display Text Orientation

In order to allow for desk or wall mounting of the IMPRES Adaptive
Multi-Unit Charger, the CDM is equipped with the ability to "flip" the
display text 180 degrees.
To do this, insert a large paper clip into the pinhole below the display
perpendicular to the desktop. A "click" indicates the toggle button has
been actuated, flipping the text 180 degrees.
Start Up
Upon Charger Power-up
LED
Line 1
Line 2
If There is No Battery in the Pocket
LED
Line 1
Line 2
SINGLE GREEN BLINK
IMPRES
OFF
NO BATTERY
12