Manually Terminating The Reconditioning Process; Manually Initiating The Reconditioning Process; Troubleshooting - Motorola IMPRES NNTN7063 Guia Del Usuario

09L67_IMPRES_MUC.book Page 7 Tuesday, December 29, 2015 11:43 AM

Manually Terminating the Reconditioning Process

At any time during the reconditioning process of a Motorola IMPRES
battery (STEADY ORANGE indication), reconditioning may be
terminated by removing and reinserting the battery back into the
charger within 5 seconds. This causes the charger to terminate the
reconditioning process and begin the charging process. The charger
indicator changes to a STEADY RED. The charger will attempt to
recondition the battery at the next battery insertion.

Manually Initiating the Reconditioning Process

Within 2–1/2 minutes of the initial insertion of an IMPRES battery
(STEADY RED indication), remove and reinsert the battery within 5
seconds to manually force reconditioning to occur. The charger
indicator changes from a STEADY RED to a STEADY ORANGE. This
forces the charger to recondition and automatically recharge the
battery. This is a useful feature to have when IMPRES batteries have
been in storage for several months or longer. Two or three manual
recondition cycles may be required to rejuvenate the batteries, due to
long term storage conditions.

TROUBLESHOOTING

The IMPRES Adaptive Charger incorporates the features of:
• A universal input (100 VAC to 240 V ac, 50/60 Hz) power supply
• A constant current rapid charger
• A negative pulse conditioning charger
• A reconditioning unit
The combination of the features listed above are unique in a desktop
charger. Therefore, operation of the radio with a battery attached while
in the charger is not recommended.
While in the charger, radio operation may result in minimally reduced
radio performance and extended battery charge time.
7