Calls Reception - Fermax CityMax ADS Extra Manual De Instrucciones

Calls reception

Being on Day or Automatic mode, the guard unit receives and stores calls in the
so called STACKS of calls waiting to be attended inmediately or later on if the
guard is absent.
There are 3 types of stacks:
* STACK of calls from Telephones: the last 20 calls from the telephones in
apartments are stored in this stack (or from the intercom units at installations
with Radial Intercom System).
* STACK of calls from PANEL 1: it stores the last incoming call from the Outdoor
Panel 1 or main panel.
* STACK of calls from PANEL 2: it stores the last incoming call from the Outdoor
Panel 2 or secondary panel (if it exists).
The guard unit starts to emit a series of "bips" that are not stopped meanwhile
there are calls in any STACK. The guard can attend and/or cancel the calls
selecting the corresponding stack in the order prefered. To do so, it is necessary
to select the call in order to set it as ACTIVE CALL (see following section).
Besides the "bips", the display of the guard unit offers information related to the
origin of the calls received as shown below:
SECTION B
Type of non-answered calls: from
telephones and/or panel
SECTION D
Data of selected or
active call.
The information that can be presented into these sections is:
SECTION B
There are unsettled calls from panels in a STACK from panels (or in both).
There are unsettled calls from telephones in the STACK of telephones.
The "A" key is used to select the ACTIVE STACK. (See note in the
following page).
SECTION C
Shows the STACK selected
:01/03
104/Po
Pag 27