18 7.4 Operating System Recovery - Bosch KTS 3a Serie Manual Original

Procedure
!
All data and programs on the USB stick will be
erased during the process of creating a bootable
recovery USB stick.
i
Administrator rights are required for creating a
bootable recovery USB stick!
i
In the following description of the creation of a
bootable recovery USB stick, the open-source
software "Rufus" is used as an example.
1. Download software for creating a bootable USB stick, e.g.
"Rufus" (https://rufus.ie).
2. Install the "Rufus" software.
3. Insert the USB stick into the computer.
4. Launch the "Rufus" software.
5. Under "Drive," select the USB stick as the target
medium.
6. Select<SELECTION>.
7. Select the desired image.
8. Select the "GPT" partitioning scheme and "UEFI
(non CSM)" target system.
i
Under "Drive name," the recovery USB stick can be
given a different name.
9. Select <START>.
10. Use <OK> to acknowledge the warning about losing
the data saved to the selected USB stick.
"
A bootable recovery USB stick will be created
(duration: approx. 1 h).
Robert Bosch GmbH
Restoring the operating system (recovery) | KTS 350 (KTS 3a Series) | 25 |
7.4 Operating system recovery
!
All data and programs on the hard drive will be
erased during the recovery process.
1. Use the power supply unit to supply the
KTS 350 (KTS 3a Series) with power.
2. Connect a keyboard to the USB port of the
KTS 350 (KTS 3a Series).
3. Insert the recovery USB stick into the USB port of
the KTS 350 (KTS 3a Series).
4. Switch the KTS 350 (KTS 3a Series) on.
 The following message will be displayed:
covery System
.
5. Select <OK>.
 The following message will be displayed:
you really want to recover your Com-
puter?
6. Select <Yes>.
 The following message will be displayed:
ING! ALL DATA ON HARD DISK DRIVE
C: WILL BE LOST. Please be patient
while recovery process is running.
Proceed with recovering?
7. Select <Yes>.
 The recovery will be started (duration: approx.
40 min). The following message will be dis-
Press any key to continue.
played:
8. Press any key.
9. Remove the recovery USB stick.
10. Press E.
 The KTS 350 (KTS 3a Series) will be shut down.
11. Switch the KTS 350 (KTS 3a Series) on.
 Windows will launch and begin initial commis-
sioning.
12. Read and follow the instructions on the screen.
13. Remove the USB keyboard.
"
The recovery is complete.
14. Install and perform the licensing process for
ESI[tronic] 2.0 (optional).
en
Re-
Would
WARN-
|
1 689 989 293 2020-08-24