Assembly Of Misting Equipment; Adjustment Of Shoulder Straps - Solo Port 423 Manual De Instrucciones

Assembly of misting equipment; Adjustment of shoulder straps

7. Assembly of misting equipment

Completely assemble the mistblower before its
first use.
Affix spraying-attachments to unit as shown in Fig.
3 and 4. (Installation sequence from 1 to 6)
Fig. 4
Make sure the elbow of the pleated hose is
pushed all the way over the welt on the blower
outlet. Then tighten the clamp securely
(Fig. 4, Pos. A).
Secure pleated hose to elbow with clamp
(Fig. 4, Pos. B).
ENGLISH 8
All manuals and user guides at all-guides.com
Fig. 5
Fig. 3
Check hose connection to on/off tap and retighten
cap nut if required.
Shut on/off tap, fill some plain water in formula tank
and check for any leakage.
Note: The spray tube can be twisted and turned in
the pleated hose with the handle. Ensure that all
hose and cable connections are safe and without
sharp bends.
Fig. 6
Place the mistblower on the back and connect to
quick couplings on either side.
The straps can be adjusted to the required length
with friction slides. Simply pull down both strap
ends to tighten straps (a).
Strap tension can be released by lifting both friction
slides (b).
Note:
The shoulder straps are correctly adjusted when
the back plate of the mist-blower rests firmly
against the back of the operator.

8. Adjustment of shoulder straps