Setting Up The Cleaner; Before Use; Fill Up Detergent Tank - Nilfisk NEPTUNE 1-22 EU Serie Instrucciones De Operación

3 Before starting the cleaner
3.1

Setting up the cleaner

3.2

Before use

3.3

Fill up detergent tank

Options / model variants
1)
Original instruction
Every fuel-burning appliance,
such as pressure washers, de-
pends upon a proper mix of fuel
and air (by weight) for proper
combustion. Therefore some
adjustment of the air regulation
to the burner may be necessary
to take account of altitude and
the resulting air pressure. This
is true whether your fuel is Ker-
osene or Diesel.
Your Nilfisk-ALTO hot water
pressure washer was thor-
oughly tested and adjusted for
°
Max 10
1)
NEPTUNE 1, NEPTUNE 2
optimum performance before
it left our factory. The factory is
located at approximately 140m
(450 ft) above sea level, and the
combustion settings are optimal
for that elevation.
If your location is higher than
1200m (3900 ft) above sea lev-
el, your burner may require re-
adjustment for proper perfor-
mance and best fuel economy.
Contact your Dealer or Nilfisk-
ALTO for assistance.
1. Before using the cleaner for
the first time, check it care-
fully to detect any faults or
damage.
2. Run the machine only when
it is in perfect condition.
3. The slope on which the high
pressure cleaner is placed
must not exceed more than
10 in any direction.
o
1. Fill up detergent tank with
prediluted detergent.
Capacity see chapter 9.4 Tech-
nical Data
NEPTUNE 2 Special
9