Installation; Unpacking The Switch; Package Contents; Unpacking Steps - Dell Networking S6000 Guía De Introducción

Installation

Unpacking the Switch

This section describes the package contents and the steps to unpack the S6000
switch.

Package Contents

When unpacking each switch, make sure that the following items are included:
• One S6000 switch
• One RJ-45 to DB-9 female cable
• Two sets of rail kits (no tools required)
• Two PSUs
• One AC power cord (country/region specific)
• Getting Started Guide
• Safety and Regulatory Information
• Warranty and Support Information
• Software License Agreement

Unpacking Steps

NOTE:
Before unpacking the switch, inspect the container and immediately report
any evidence of damage.
Step Task
Place the container on a clean, flat surface and cut all straps securing the container.
1
Open the container or remove the container top.
2
Carefully remove the switch from the container and place it on a secure and clean
3
surface.
Remove all packing material.
4
Inspect the product and accessories for damage.
5
Installation
17