Assigning An Ip Address To A Vlan; Connecting The S6000 To The Network - Dell Networking S6000 Guía De Introducción

Assigning an IP Address to a VLAN

VLANs are a Layer 2 feature. For two physical interfaces on different VLANs
to communicate, assign an IP address to the VLANs to route traffic between the
two interfaces. The shutdown command in INTERFACE mode does not affect
Layer 2 traffic on the interface.
NOTE: You cannot assign an IP address to the Default VLAN, which, by default,
is VLAN 1. To assign another VLAN ID to the Default VLAN, use the default
vlan-id vlan-id command from the configuration mode.
To assign an IP address to a VLAN, follow this step.
Task
Access the INTERFACE
VLAN mode of the
VLAN to which you want
to assign the IP address.
Configure an IP addresses
and mask on the interface.

Connecting the S6000 to the Network

After you have completed the hardware installation and software configuration
for the S6000 system, you can connect to your company network by following
your company's cabling requirements.
36
Installing the Software
Command Syntax
ip address ip-address mask
[secondary]
Command Mode
INTERFACE