Dell Networking S6000 Guía De Introducción página 37

To view which interfaces are tagged or untagged and to view which VLAN the
interfaces belong, use the show vlan command. To view just the interfaces that
are in Layer 2 mode, use the show interfaces switchport command in EXEC
Privilege mode or EXEC mode.
To tag frames leaving an interface in Layer 2 mode, assign that interface as
tagged to a port-based VLAN to tag it with that VLAN ID.
To tag interfaces, follow these steps.
Step Task
Access the
1
INTERFACE VLAN
mode of the VLAN to
which you want to
assign the interface.
Enable an interface to
2
include the IEEE
802.1Q tag header.
This command is
available only in
VLAN interfaces.
To move untagged interfaces from the Default VLAN to another VLAN, use the
untagged command:
To move untagged interfaces, follow these steps.
Step Task
Access the
1
INTERFACE VLAN
mode of the VLAN to
which you want to
assign the interface.
Configure an interface
2
as untagged. This
command is available
only in VLAN
interfaces.
Command Syntax
interface vlan vlan-id
tagged interface
Command Syntax
interface vlan vlan-id
untagged interface
Command Mode
CONFIGURATION
INTERFACE
Command Mode
CONFIGURATION
INTERFACE
Installing the Software
35