Configuring The Management Route; Configuring The Username And Password; Configuring The Enable Password - Dell Networking S6000 Guía De Introducción

Configuring the Management Route

Define a path from the S6000 to the network from which you are accessing the
S6000 remotely. Management routes are separate from IP routes and are used to
manage the S6000 through the management port.
To configure a management route, follow this step.
Task
Configure a
management route to
the network from
which you are
accessing the system.

Configuring the Username and Password

To access the system remotely, configure a system username and password.
To configure a username and password, follow this step.
Task
Configure a username
and password to
access the system
remotely.

Configuring the Enable Password

Access EXEC Privilege mode using the enable command. EXEC Privilege
mode is unrestricted by default. As a basic security measure, configure a
password. There are two types of enable passwords:
• enable password — stores the password in the running/startup configuration
using a data encryption standard (DES)-encryption method.
• enable secret — stores the password in the running/startup configuration
using a stronger, MD5-encryption method.
Dell Networking recommends using the enable secret password.
Command Syntax
management route ip-address/mask
gateway
Command Syntax
username username password
[encryption-type]
Command Mode
CONFIGURATION
Command Mode
CONFIGURATION
Installing the Software
33